Reference: FL01A24

Brand: AIR GPL

UNIVERSAL FILTER Ø14 FL01A24

(0)
Universal gaseous LPG filter for LPG pipes Ø 14mm intended for the protection of LPG injectors adaptable to a large number of LPG systems Approved 67 r 01 PROMOTIONAL RATE BY QUANTITY RESERVED FOR PROFESSIONALS
€17.01 €18.90
More
(Discount by quantity reserved for professionals) See table above

Reference: FPG2512-A25

FILGAZ FILTER FPG25 DACIA RENAULT LPG Ø12 FPG2512-A25

(0)
FILGAZ FPG25 LPG filter Ø12X12 (Discount by quantity reserved for professionals) See table below "Low pressure" gas phase filter used on the original assemblies of Dacia and Renault vehicles. The inlet and outlet diameters are 12 or 14 mm. Originally installed in the DACIA range: Sandero, Duster... Renault: Captur, Clio 5...  
€17.00
More
In stock

Reference: LR0275FKN208A-13 674072000

Brand: Landirenzo

FILTER DACIA OPEL LI02-IG1 LR0275FKN208-A13

(0)
Liquid filter for Landi Renzo LI02 or IG1 solenoid valve (with seal) located on the Dacia Sandéro, Renault Clio, Opel corsa Mériva Agila vapo Attention ! it is mandatory to have this LPG part fitted by a car professionalOur company disclaims all liability in the event of an accident . Discount by quantity reserved for professionals See table below
€5.94
More
In stock
All best sellers
  • Banner

EMULATOR AEB UNIVERSAL
  • EMULATOR AEB UNIVERSAL
  • EMULATOR AEB UNIVERSAL
  • EMULATOR AEB UNIVERSAL

EMULATOR TYPE JAGUAR AEB394-2268A-E35

AEB394-2268A-E35
AEB

Emulator is used on some Jaguar. This emulator has been designed to maintain a constant voltage of the fuel pressure sensor on Jaguar thus avoiding the ignition of the engine fault warning light. the emulator works only when the engine is on LPG It is necessary to install AEB J when the vehicle is equipped with a sensor at the end of the injection rail note below

€95.00
VAT included
Quantity
On order only

Description

NB: If it is necessary to install the emulator on a car which has a pressure sensor (located at the end of the petrol injection rail) different from that shown in the diagram, follow the procedure below:

1) Using a digital multimeter, check voltage on all 3 wires of fuel pressure sensor with engine running and CONNECTOR INSERTED.

2) The wire to which the green wire of the emulator will be connected will have a voltage between 2 and 3.5 Volts which varies according to the fuel pressure; as you accelerate, you will notice the variation in this tension. The other 2 wires from the fuel pressure sensor will have a voltage of 5 and 0 Volt (Ground) respectively. The emulator can only be applied to the cars listed in the list below.

Recommended cars for installation Jaguar X-Type 2.5i V6 24v Multipoint '02 - XB (OBD). Jaguar X-Type 3.0i V6

Product Details
AEB
AEB394-2268A-E35
0
Comments (0)
Grade
No customer reviews for the moment.
16 other products in the same category:

Reference: aeb160u6-EM5495-E35

AEB EMULATOR 160-6U 6 CYL UNIVERSAL EM5495-E35

(0)
Pitagora AEB160-U 6-cylinder emulator with universal harness allowing the cut-off and emulation of gasoline injectors when the engine is in Gas mode. Universal beam Emulators distributed by AIRGPL and in its network of LPG garages
€98.00
More
Last items in stock

Reference: BR4042-E30

Brand: BRC

BRC SENSOR P&D PROGRAMMING BR4042-E30

(0)
LPG pressure sensor for 6 and 8 cylinders of BRC Sequent plug & drive LPG systems essential for programming LPG Sequent Plug and Drive systems from BRC TA OMVL & GFI
€89.50
More
On order delay between 3 and 5 days

Reference: AE0133-E26

AEB SENSOR 025 AE0133-E26

(0)
MAP sensor AEB 025 — for LPG installations ( OMVL , BIGAS , Zavoli, etc.) Description :Pressure and vacuum sensor (MAP) model AEB 025 , fitted as standard on many generations of LPG/CNG equipment: OMVL (Dream XXI, Dream…), Bigas Sigas, Emmegas, AEB King, Romano, Tartarini, Zavoli, Elpigaz, Princegas, Öcotec, and others Usage / Compatibility:Intended for...
€55.00
More
Last items in stock

Reference: AEFLC12/12-A10

Brand: AIR GPL

FILTER WITH SOCKET FOR BOSCH AEFLC12/12-A10 PRESSURE SENSOR

(0)
Gas filter FL01C Ø12/12 with socket for Bosch gas pressure and temperature sensor. The LPG filter is used between the reducer and the injectors. This filter is most often used as a replacement for filters in sequential gas injection systems from manufacturers such as Nécam, Bigas, Prins, Landi Renzo, Lovato. (Filter sold without the Bosch sensor)
€19.80 €22.00
More
Last items in stock

Reference: ST6-M36

Brand: EUROPEGAS

LPG TEMPERATURE PROBE 4.5ohms ST6-M33

(0)
T-junction for connecting two Ø16 water hoses, equipped with a temperature probe with a resistance of 4.7 ohms (to be soldered). Compatible with many LPG systems.
€23.40
More
In stock

Reference: BR0415-E28

Brand: BRC

BRC SENSOR WITH HOLE BRC BR0415-E28

(0)
BRC pressure and temperature sensor (with hole) for Sequent S 24 and S 56 systems also used on certain LPG systems for Chevrolet Matiz and Kalos
€87.90
More
Last items in stock

Reference: DE802041- BR0384

Brand: BRC

LPG SENSOR BRC BOARD/ P1TURBO BR0384

(0)
MAP / P1 TURBO BRC LPG pressure sensor for programming Sequent type LPG systems and others (delivery time between 3 and 7 working days)
€236.80
More
Last items in stock

Reference: BR2544-M36

Brand: BRC

Gas temperature probe for BRC Genius BR2544-M36 vaporizer/regulator

(0)
Gas temperature probe for BRC Genius vaporizer regulator, older model. Cette sonde permet de mesurer la température du gaz au niveau du vapo-détendeur GPL afin d'assurer le bon fonctionnement et la gestion du système d'injection GPL. Part intended for older generation BRC Genius vaporizers .
€34.50
More
In stock

Follow us on Facebook