Valtek Ø8 solenoid valve for Prins VSI vaporizer regulator
This Valtek LPG solenoid valve is intended for replacing the solenoid valve mounted on Prins VSI LPG vaporizer regulators equipped with an LPG supply via Ø8 mm hose.
It provides an economical alternative to the original Prins solenoid valve while allowing the existing vaporizer regulator to be retained when it is still in good condition.
This solenoid valve is specifically designed for Prins VSI 1 and VSI 2 systems with an 8 mm inlet connection. Prins technical documentation also lists Valtek among the manufacturers of LPG shut-off valves used with VSI systems.
Main features
- Brand: Valtek
- Type: LPG solenoid valve for Prins Vsi LPG vaporizer
- Application: Prins LPG regulator vaporizer
- Systems: Prins VSI 1 and VSI 2
- Inlet diameter: Ø8 mm
- Reference: VA4514-T18
- Use: Replacing a faulty solenoid valve
- Advantage: economical replacement solution
- Application: LPG / Autogas / VSI regulator vaporizer
Prins solenoid valve replacement
When the solenoid valve on the pressure regulator is faulty, it is not always necessary to replace the entire regulator. If the Prins regulator is in good condition, replacing the solenoid valve can restore the LPG system to working order at a lower cost.
Important: Before ordering, be sure to check the model of the vaporizer regulator, the type of connection, and the diameter of the LPG inlet. The 6 mm and 8 mm versions are not interchangeable.
Assembly advice
Since the LPG circuit is under pressure, the replacement of the solenoid valve must be carried out under appropriate safety conditions and, preferably, by a professional qualified in the installation and maintenance of LPG systems.
After intervention, carefully check the circuit for leaks before putting the vehicle back into service.
