Reference: FL01A24

Brand: AIR GPL

UNIVERSAL FILTER Ø14 FL01A24

(0)
Universal gaseous LPG filter for LPG pipes Ø 14mm intended for the protection of LPG injectors adaptable to a large number of LPG systems Approved 67 r 01 PROMOTIONAL RATE BY QUANTITY RESERVED FOR PROFESSIONALS
€14.17 €15.75
More
(Discount by quantity reserved for professionals) See table above

Reference: AD6147-GZ2010-C50

Brand: AIR GPL

LPG GAS BOTTLE ADAPTER 13KG GZ2010-C50

(0)
Adapter for filling 13Kg gas bottles. Cup for France, Italy, Portugal. Possibility of adding another adapter for other countries Filling of gas cylinders prohibited in France and ItalyAdapter sold without seal! (sealing is metal to metal) On PROMO secure camper van bottle follow the link SECURE GAS BOTTLE DIRECT ACCESS A DEMONSTRATION OF LPG BOTTLE FILLING
€24.17
More
In stock

Reference: LR0275FKN208A-13 674072000

Brand: Landirenzo

FILTER DACIA OPEL LI02-IG1 LR0275FKN208-A13

(0)
Liquid filter for Landi Renzo LI02 or IG1 solenoid valve (with seal) located on the Dacia Sandéro, Renault Clio, Opel corsa Mériva Agila vapo Attention ! it is mandatory to have this LPG part fitted by a car professionalOur company disclaims all liability in the event of an accident . Discount by quantity reserved for professionals See table below
€4.95
More
In stock

Reference: FPG2512-A25

FILGAZ FILTER FPG25 DACIA RENAULT LPG Ø12 FPG2512-A25

(0)
FILGAZ FPG25 LPG filter Ø12X12 (Discount by quantity reserved for professionals) See table below "Low pressure" gas phase filter used on the original assemblies of Dacia and Renault vehicles. The inlet and outlet diameters are 12 or 14 mm. Originally installed in the DACIA range: Sandero, Duster... Renault: Captur, Clio 5...  
€14.17
More
In stock
All best sellers
  • Banner

  • Out-of-Stock
TOOL PUSHES THE PISTON TO THE CALIPERS OF DISC BRAKES AV
  • TOOL PUSHES THE PISTON TO THE CALIPERS OF DISC BRAKES AV
  • TOOL PUSHES THE PISTON TO THE CALIPERS OF DISC BRAKES AV

PISTON SETTING TOOL FOR FRONT DISC BRAKE CALIPER

20kb-04066

This very specific tool is needed when replacing the rear brake pads.
It is used to push back the brake pistons.
Failure to use it during maintenance risks damaging the rear brakes.
Suitable for most calipers: ATE, BENDIX, DELCO and GIRLING

€20.83
Quantity
Out-of-Stock

Description

A necessary tool for removal and installation of new brake pads.
It can also be used with a 21mm wrench;
It is quick and easy to use to spread disc brake pistons, even with dual pistons.
Does not damage the piston, when you squeeze it back.
Protects damaged pistons.
Allows regular pressure on the piston.
Suitable for most calipers: ATE, BENDIX, DELCO and GIRLING;
Incompatible with. rear disc brake calipers.

Product Details
20kb-04066
Comments (0)
Grade
No customer reviews for the moment.
16 other products in the same category:

Reference: NF BARDAHL

Brand: VLUBE

BARDAHL BRAKE CLEANER AND DEGREASER 600ML

(0)
The BARDAHL cleaner and degreaser with a large capacity of 600ml is very powerful for cleaning and degreasing brakes, clutches (discs, drums, jaws...), but also other mechanisms (engines, clutches... DISCOUNT BY QUANTITY RESERVED FOR PROFESSIONALS (See table below)
€3.37
More
DISCOUNT BY QUANTITY RESERVED FOR PROFESSIONALS (See table below)

Reference: 20asta-ah-6512a

BRAKE FLUID TESTER TO DETECT HUMIDITY

(0)
When braking, the entire brake system heats up. This heat is transmitted to the brake fluid and condensation is created in the hoses. The color of the liquid then turns brownish. Loaded with water, its efficiency becomes insufficient, and in about two years, you lose about 5 meters under braking, which is more than considerable. So dangerous!!!
€27.12
More
In stock

Reference: 20a-50pcs

(0)
brake piston pusher kit - 50pcs (See description below)
€80.83
More
Last items in stock

Reference: AMTP127-F6

Brand: AIR GPL

LONG TAP HOLDER 25cm AMTP127-F6

(0)
25CM LONG TAP HOLDER, M3 to M8 with front/rear ratchet. Ideal for tapping a hole where access is difficult for example in the engine compartment, passenger compartment, intake manifold
€33.35
More
(Discount by quantity) see table below

Reference: 200-4.2

Brand: AIR GPL

EXTRA LONG DRILL BIT 200mm X Ø4.2 mm

(0)
DRILL BIT TA FOR MOUNTING LPG SYSTEM Drill Ø 4.2 mm High quality material, HSS 4241 high speed steel, total length 200mm Precise positioning, fast cutting, strong chip removal, good wear resistance, Suitable for spring steel, white steel, carbon steel, angle iron, aluminum, copper, wood and stainless steel
€4.70
More
(Discount by quantity) see table below

Reference: 20ms129

Brand: AIR GPL

6 / 8 /10 MM COPPER PIPE BENDER

(0)
6 / 8 / 10 mm copper pipe bender In resistant aluminium, hinges for intensive use. For bending 6, 8 and 10 mm copper and aluminum pipes. Suitable for central heating and hydraulic pipes. Compact size. Length: 270mm.
€24.17
More
In stock

Reference: 200-8

Brand: AIR GPL

EXTRA LONG DRILL BIT 200mm X Ø8 mm

(0)
DRILL BIT Ø 8mm FOR TA LPG SYSTEM There are 8 kinds of diameters, 4 4.2 4.5 5 5.2 6 8 10mm, High quality material, HSS 4241 high speed steel, total length 200mm Precise positioning, fast cutting, strong chip removal, good wear resistance, Suitable for spring steel, white steel, carbon steel, angle iron, aluminum, copper, wood and stainless steel
€6.66
More
(Discount by quantity) see table below

Reference: KS

KS-TOOL PNEUMATIC PISTON REPELLERS

(0)
KS TOOL brand pneumatic piston pusher used for resetting the brake piston. Indispensable in a mechanical workshop
€129.00
More
Last items in stock

Follow us on Facebook